Treat Holder Tutorial

 Hi everyone! This is GiGi from The Cricut Bug and I'm sharing this treat holder tutorial.

I started this project using the tag shaped die from the Shaker Basics 2.

I lined up the die on one edge of the paper and ran it through the cutting  machine just to the end, not going all the way.

Then I took the die off, flipper the paper, and lined the die up again on the side of the paper, cutting to the end but not all the way through.

After I got both sides cut, I trimmed the centers where it was still connected with a pair of scissors.

Using my score board, I scored in each side at 3 7/8 and added the mat layer from the Shaker Basics 2 die set.

I cut the banner pieces using the Banner Dies and cut out the center swirl from the Candy Cane Frame Die.

I punched a 3/4 inch circle and 1 inch circle and glued all the pieces together, adding Stickles over the entire thing.

I stamped the sentiment onto the banner using the Stacey-Sign Board stamp set and used a hole punch to punch the hole for the ribbon closure.

I stamped and colored the Sweet Christmas Wishes Digital Stamp and added Stickles to her dress and bow.

I added the bag of M&M's to the inside and tied it closed with some ribbon, adding the candy onto the ribbon with pop dots.

To finish, I added the banner die and pop dotted the girl to the front.

I hope you all liked my project for today and thanks for visiting!
Have a great day!

GiGi